These solar charge controllers are equipped with an LCD screen and 2 USB outputs. The models for 12 and 24 V battery voltage have automatic voltage detection and range from 5A to 30A. The 48V models have a charge current of 10, 20 or 30A.
Liquid crystal display
For status monitoring and set-up
Load output
Over-discharge of the battery can be prevented by connecting all loads to the load output. The load output will disconnect the load when the battery has been discharged to a pre-set voltage. Some loads (especially inverters) can best be connected directly to the battery, and the inverter remote control connected to the load output. A special interface cable may be needed, please see the manual. The connect and disconnect voltages are adjustable.
Day/night timing of the load output
This option allows for a pre-set ON-time after dusk.
Programmable battery charge algorithm
Preprogrammed algorithms for AGM, GEL, Flooded or LiFePO4 batteries (with internal BMS only)
Two 5 Volt USB outputs
Maximum current (both outputs combined): 2A
- Order refer.: SCC040020050
- Description: Victron BlueSolar PWM-LCD&USB charge controller
- Voltage (VDC): 48
- Charge current (A): 20
- Maximum solar array power:
- Maximum PV open circuit voltage:
- Connexion solar panels:
- Datacommunication:
- Display: LED
- Dimensions in mm (lxwxh): 101x184x47
- Weight (kg): 0,30
- Controller: PWM
- Temperature sensored: On request
- Number of charge output: 1
- Safety: IEC62109-1
- Emission: EN61000-6-1, EN61000-6-3, ISO7637-2
- Automotive Directive: